We do our best to have as much inventory as possible. These instructions are useful for all bedsides sold by Advanced Fiberglass Concepts - therefore some of the steps may not be needed or should be slightly altered to suit your particular vehicle and product needs. If you need further assistance with this installation, feel free to call us-one of our techs will be more than happy to help you. Therefore, please be patient when you start this job. Please keep in mind-although all of our products are made from factory steel fenders, hoods, and bedsides, there is a difference in fit because of the thickness of the fiberglass compared to steel. This is because fiberglass bedsides are thicker than steel. You may need to sand some of the bedside down for desired fitment. You will need to be patient to get a good fit. There are supports in all trucks, although you can modify your old mounts to work with the fiberglass bedsides or you can fabricate your own custom mounts. Step 6: Now as the last step, it is important to secure the front and rear portion of the wheel well. Do not over tighten! The fiberglass bedside will make sounds like it is cracking-this is common as it is fiberglass, so do not worry. Once you have the gaps spaced, tighten down the bolts. Drill holes out with a 3/8 drill bit-the reason for this is so you can move the bedside back and forth to align the gap. We recommend our customers to use 4-6 evenly spaced bolts along the inner bed rail, one between the cab and the bed, and 1-2 bolts around the tail light area. Step 5: Once you are happy with the alignment, it is time to bolt down the bedsides. You may have to sand or trim off the inner bed or fiberglass to get it into the correct position. Step 4: Align the fiberglass bedsides with all the bodylines on the cab and the taillights. Best way to start, is by hanging the new fiberglass bedside over the bed rail. Step 3: Once the stock bedsides have been removed, the inner bed structure will be showing and then it is time to mount our fiberglass bedsides. Step 2: Use a spot weld cutter to remove the factory bedside spot welds, which are located around the bedside. Step 1: Remove the taillights, as well as the bumper. Metal Shears or Sawzall or Plasma CutterĪlthough this is not necessary, we always recommend removing the bed to make the process easier.Screw drivers (Flat head and Phillips).Advanced Fiberglass Concepts LLC does recommend that a professional install for a seamless fit install these products. Also, you will reuse most of your stock hardware during this installation-it is typical to have a few screws and bolts left over, however. You will need a few hand tools and a few hours of time, depending on the products you have purchased.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |